The ultimate kit for your HPI Savage Flux HP! All you need is a power supply for the charger and you're ready to run. These packs will work perfectly with no modifications required.
If you're looking for an insane amount of power, these are the packs for you!
Warning: The Savage Flux ESC has a soft lipo cutoff as the factory default setting. This means that it won’t cut the power to your system when the pack voltage reaches the cutoff point. We highly recommend getting a Castle Link which will allow you to program the ESC to a hard cutoff. This will protect you from over-discharging your lipo pack and voiding your warranty.
Kit Includes:
Two Lipo 5250 3S 11.1V Packs
62+mph in brushless setup(11.1 Volts)
32 minutes average runtime(5250mah Capacity) Drops in standard battery tray with no mod required 45mm X 138mm X 26mm 354 grams5C Fast Charge Capable
Water-sealed for all-weather protection Built today with factory fresh cells
We add the connectors and balancing taps for you Money Back GuaranteeComes with 12awg Deans Ultra Female Plug Wired to fit Savage Flux HP tray Hyperion EOS0615iDUO3 Balance Charger
NEW! Now includes Lipo and LiFePO4/A123 Cycle mode. Max charge rate has been raised from 10A to 15A per port.
- Most versatile charger on the market today!
- Capable of quick charge rates
- Ultimate charger for 7S-12S Flight packs or for those who just want to charge two packs at once.
- Charges NIMH, NICD, Lipo, LiFePO4/A123 & Lead Acid
- 1-16 NIMH-NICD, 1-6 Lipo, 1-6 LiFePO4/A123, 1-12 Lead Acid cells per port
- Up to 15 amp charge rate per port
- 360 Watt max charge output(180W per port)
- 11-28V DC only (needs a separate power supply)
- Comes with built-in Dataport and supplied USB cable
- Comes with two Integrated LBA Balancers
- Also includes two Hyperion 2S-6S Multi-Adapters
- Comes with 12awg Deans Ultra Male Plug
This charger is incredibly versatile and has 8 available modes!
- Charge only mode(SOLO or SYNC)
- Balance Charge mode(SOLO or SYNC)
- Balance only mode (SOLO or SYNC)
- Discharge mode(50W per port w/ 10A max current)
- Lipo & LiFePO4/A123 Storage mode(Allows fast and simple discharge to 60% capacity for proper storage voltage which equals longer battery life)
This charger is capable of balance charging two Lipo packs at once with no additional accessories to purchase. In this case, you can charge 2 separate but similar Lipo or LiFePO4/A123 packs as a single unit in "SYNC" mode to make packs up to 12S at 360W max charge power or you can charge two completely different packs in "SOLO" mode on each port at the same time.
This charger is carefully designed with many built-in safety features such as reverse polarity protection, input voltage error warning, and cell count mismatch warnings for lithium chemistry batteries.
Terminal Capacity Selection (TCS)
Temperature Sensor Port
20 User-definable Memory Positions per port(40 total)
Lipo Sack
Fire resistant Lipo Sack 9" X 12"
Use this product while charging, storing or transporting a lipo battery pack. The use of a Lipo Sack does not guarantee protection of surrounding surfaces. It is simply intended to mitigate the effects of a battery failure during charging or after a crash. MaxAmps takes no responsiblilty for effectiveness of the lipo sack. Never charge unattended. Always keep your lipo packs in a fireproof container in addition to the lipo sack.
